1th Step: Connect the water cooler and air pump, and turn on the power of the machine.
2th Step: Use the control panel to point out the light and check if the machine light path is in the center of the lens. (Note: Before the laser tube emits light, make sure that the water cooler keeps the water cooling cycle)
3th Step: Connect the data cable between the computer and the machine, read the board information.
1) When the data cable is a USB data cable.
2) When the data cable is a network cable. It is necessary to modify the IP4 address of the network cable port of the computer and the board to: 192.168.1.100.
